INTRODUCTION:
ANTIFOAM SN 6010 is an APEO free silicone based antifoam emulsion recommended for many types of applications.
ANTIFOAM SN 6010 is supplied at its most effective working concentration and requires no further dilution.
ANTIFOAM SN 6010 disperses readily in aqueous systems, and can be added before or after foaming has started depending on the characteristics of the system, i.e. temperature, degree of agitation, composition, etc.
TYPICAL PROPERTIES OF ANTIFOAM SN 6010:
Appearance: Milky white emulsion
Viscosity: 2000-3500 cps (25°C)
pH: 6.0-8.0
Density (25°C): approx. 1.0 gr/cm3
Solubility: Dispersible in water
ANTIFOAM SN 6010 is an APEO free silicone based antifoam emulsion recommended for many types of applications.
KEYWORDS:
ANTIFOAM, ANTIFOAM SN, Antifoam S, Antifoam S200, Acronal, AQAGloss, FoamStar, Joncryl, Antifoam SE-15, EUROLUB ANTIFOAM S
APPLICATION PROPERTIES OF ANTIFOAM SN 6010:
ANTIFOAM SN 6010 can be widely used in the paint, textile, paper, glass and chemical industries.
ANTIFOAM SN 6010 is a ready-to-use and is should be added directly to the foaming system at initial concentration of 0.2 – 1.0 gr/lt.
PRODUCT HANDLING – STORAGE – SHELFLIFE OF ANTIFOAM SN 6010:
ANTIFOAM SN 6010 is not expected that this product will give rise to any storage or handling difficulties if properly stored in original packings or in clean, covered, suitable containers at normal temperatures ( 5 - 40 °C) for a maximum period of 6 months.
ANTIFOAM SN 6010 must be protected from freezing.
Exposures to extremes of heat and cold should be avoided and special signs and instructions indicated on original packings should be carefully observed.